Wide-voltage input
Universal 85–265 VAC input supports flexible electric heating project planning.
TELIN / ELECTRIC FLOOR HEATING
UTH-170R
Electric
Thermostat
A compact wall-mounted controller for practical electric floor-heating projects.
The TELIN UTH-170R is an electronic wall-mounted controller for electric floor-heating systems. It accepts universal 85–265 VAC input, supports up to 4 kW output through a single 18 A resistive-load circuit, and uses an NTC temperature sensor for room-temperature control. Its flame-retarding external case is designed for clear operation and practical installation across residential, hospitality, commercial and institutional applications.
Product view · UTH-170R digital temperature controller with NTC sensor
AT A GLANCE
Simple control for electric heating systems.
UTH-170R is designed for projects that need an electronic wall-mounted electric heating controller. The FND temperature display, NTC sensor input and selectable sensor or timer operation provide a practical control point for electric floor-heating rooms and other electric heating applications.
Sensor or timer mode
Use sensor mode with the NTC temperature sensor, or configure timer mode when the sensor is disconnected according to the installation plan.
Clear status indication
The green SET lamp indicates setting changes, while the red RUN lamp indicates output operation and can flicker when an error occurs.
TECHNICAL PROFILE
Product specifications
ModelUTH-170R
Heating systemElectric
Product typeElectronic floor-heating thermostat
Input voltage85–265 VAC universal
Relay18 A resistive load
External caseFlame retarding
Dimensions70 × 120 × 27 mm
Maximum output4 kW
SensorNTC, 5 kΩ at 25°C
Temperature precision±1°C
Temp. range-9°C to 80°C
Output delay1–60 seconds, basic 20 s
Operation modesSensor / timer
SafetySensor fault and optional overheat protection
The UTH-170R manual specifies universal 85–265 VAC input/output, one circuit, 18 A resistive-load capacity and a maximum 4 kW output. If the temperature sensor is disconnected, the controller can convert to timer mode; the optional overheating sensor can shut off output when the set limit is exceeded. Confirm the final load, wiring, protection and sensor configuration against the project electrical plan before installation.
INSTALLATION WORKFLOW
Keep the installation clear.
Plan the controller position, NTC sensor route and electrical protection before fixing the wall housing. The UTH-170R supports sensor mode and a timer mode that requires the temperature sensor to be disconnected. The product views can be used to review the front interface, rear housing and terminal access during project preparation.
- 01 Confirm the wall position and room control height
- 02 Route and protect the NTC temperature sensor
- 03 Select sensor mode or timer mode according to the project design
- 04 Connect the single electric-heating circuit and verify protection
- 05 Test the display, SET/RUN lamps, setpoint and heating response
PRODUCT VIEWS
Review the UTH-170R before planning the installation.
The product gallery shows the UTH-170R controller, NTC sensor, wall housing, rear structure and terminal-access view. The supplied manual also describes an optional UTH-remocon 1 remote for controller power and temperature setpoint up/down.
APPLICATIONS
Designed for multiple electric-heating environments.
Suitable for electric floor-heating projects in hotels, villas, apartments, office buildings, hospitals, schools and malls, subject to the project electrical design and the stated 4 kW / 18 A resistive-load limit.
PROJECT INQUIRY
Plan your UTH-170R project.
Share the heating load, input voltage, sensor arrangement, installation environment and required quantity with the TELIN team.
